Stove pipe hook up, drill/driver fitted with extra-long 3/8-inch drill bit
Install the drip leg and cap as shown in Photo 3.
Do NOT use Teflon tape on these threads. The rules provided here are based on the CSA installation code used in Canada.
How to Put a Stove Pipe Together | Home Guides | SF Gate
Align the hole with the edge of the vent pipe. Set a fireproof pad onto the floor at the desired installation location. A straight up double wall flue pipe assembly.
Reassemble the union Reconnect the union. Purchase a inch piece of single-wall stovepipe using the measurements. Apply a bead of silicone caulk around the 2-inch vent where it passes through the interior wall.
Its only a matter of matching the pipe to the flange. Seal a Stovepipe Wood stoves and stovepipes were made for each other. Things You Will Need. The clearance information is found on the labels attached to the pipe and in the manufacturer's installation instructions.
Tools List for Installing a Pellet Stove
One end will have a slight bulge at one end. The inch section is for an example. The first seam is a longitudinal seam that runs along the length of the pipe; the second seam is the connection between the ends of two pipes.
Keep the screw 3 inches in from either end of the pipe.
Cut along the large outer circle with a reciprocating saw. The crimped ends male of the sections must be oriented towards the appliance so that falling dust and condensation stay inside the pipe.
Trace the vent pipe outline onto the wall, then remove the pipe from the stove. This end fitting can be either male or female.
The assembly should be as short and direct as possible between the stove and chimney. Here are some additional guidelines: Use the same Stove pipe hook up to install more pieces by fitting the larger end onto the smaller end.
Just remove the short lengths of pipe and fittings, as shown in Photos 2 and 3, clean the threads, apply new Teflon tape to the threads, and reconnect the entire assembly exactly as it was before. Rotate the pipes so the longitudinal seams are aligned. There are two types of seams that must be put together correctly to ensure the pipe operates correctly.